Clears all cameras or other view items from one or more XProtect Smart Client views.
This command removes all view items from the view, leaving an empty view layout with the same original layout.
- Requires VMS connection and will attempt to connect automatically
- Requires VMS version 21.1
After ensuring there is an open connection to the Management Server, we prompt for a view selection, and then clear the view of all view items, except the -WhatIf parameter is present, so you will only see a message indicating the change that would occur if you omitted the -WhatIf switch.
Specifies that the updated view should be passed on through the pipeline, or out to the terminal.
Specifies one or more views to be cleared of all view items.
Prompts you for confirmation before running the cmdlet.
Shows what would happen if the cmdlet runs. The cmdlet is not run.
This cmdlet supports the common parameters: -Debug, -ErrorAction, -ErrorVariable, -InformationAction, -InformationVariable, -OutVariable, -OutBuffer, -PipelineVariable, -Verbose, -WarningAction, and -WarningVariable. For more information, see about_CommonParameters.